安装进口水用电磁阀需注意的十点要素
原文：
1、电磁阀的工作介质应清洁无颗粒杂质，电磁阀内件表面上的污物及过滤器，需定期清洁干净。
2、安装时电磁阀线圈向上，并保持垂直位置，电磁阀上箭头或标记应与管道流向一致，不得安装在有溅水或漏水的地方。
3、水用电磁阀安装电磁阀前，管道必须清洗干净。建议在阀前安装过滤器，蒸汽管道安装疏水阀。
4、在管路系统中，安装在支路上的电磁阀通径应小于主管道阀门的通径。
5、电磁水阀不能在爆炸危险场合使用。
6、不能将阀安装在管道的低凹处，以免因蒸汽冷凝水、杂质等沉淀在阀内而防碍动作。
7、在电磁阀发生故障时，为了及时隔离电磁阀，并保证系统正常运行，最好安装旁路装置。
8、水用电磁阀在管路刚性不足情况下，建议把阀前管道用支架固定，以免电磁阀工作时引起振动。
9、水用电磁阀在安装前，要注意看清产品标牌，认真阅读使用说明书，判断产品是否符合使用条件。
10、水用电磁阀前后管道上需安装压力表，以便观察管道压力。安装水用电磁阀需注意的十点要素。
译文：
The working medium 1, solenoid valve should be clean and free of impurities, electromagnetic valve and surface dirt on the filters need to clean regularly.
2, installation solenoid valve coil upward, and maintain the vertical position, solenoid valve on the arrow or markings should be consistent with the pipeline flow, shall not be installed in a splash of water or Water Leakage place.
Solenoid valve installation 3, water solenoid valve, the piping must be clean. Recommended valve installed before the filter, the installation of steam pipe drain valve.
4, in the pipeline system, the electromagnetic valve is installed in the branch diameter should be less than the main pipeline valves.
5, the electromagnetic valve can not be used in explosive situations.
6, can not be installed in the pipeline valve low recesses, so as to avoid condensation of water vapor, impurities deposited on the valve and prevents action.
7, when the solenoid valve failure, in order to prompt isolation valve, and ensure the normal running, best to install the bypass device.
8, solenoid valve for water insufficient rigidity in the pipeline case, suggested that the pipe before the valve with a fixed support, in order to avoid vibration caused by electromagnetic valve work.
9, solenoid valve for water before installation, pay attention to see the product label, carefully read the instruction manual, to determine whether the products meet the conditions of use.
10, water solenoid valve should be installed around the pipe in order to observe the pressure gauge, pressure piping.
本文网址:http://www.dghwvalve.com/
